Barnstead 47900 Operation Manual page 29

8 S & 4 16 S
EGMENT X
"rmP.r" segments (ramp to a setpoint at
degrees per second, minute or hour) and
"rmP.t" segments (ramp to setpoint in a spe-
cific amount of time). See "Setting the
Segment Type" for an explanation on how to
set a ramp segment.
1. Press the PAGE button until you
2. Press the SCROLL button until dis-
3. Press the UP or DOWN button to tog-
dwL.U: Setting Dwell Units
Dwell units are time units which are used in
"dwELL" segments (amount of time to remain
at a specific temperature ). See "Setting the
Segment Type" for an explanation on how to
set a dwell segment.
1. Press the PAGE button until you
2. Press the SCROLL button until dis-
3. Press the UP or DOWN button to tog-
CYC.n: Setting the Number of Cycles
Set the number of times a group of segments
or programs are to be repeated by following
the steps listed below.
1. Press the PAGE button until you
P
EGMENT ROGRAMMABLE
reach the program list (ProG LiSt).
play reads, "rmP.U."
gle between seconds, minutes and
hours.
reach the program list (ProG LiSt).
play reads, "dwL.U."
gle between seconds, minutes and
hours.
reach the program list (ProG LiSt).
M /OTP
ODELS W
29