For Users On Resilient 3300 Icp Systems; Using Your Phone; Adjusting The Ringer Volume; Adjusting The Handset Receiver Volume - Mitel 5005 User Manual

For Users on Resilient 3300 ICP Systems

If during a call, you hear two beeps repeated every 20 seconds it means that
your phone is switching to a secondary 3300 ICP system. The call continues
but the keys and features on your phone stop working. The keys and most
features begin working again after you hang up. Normal operation resumes
when your phone switches back to the primary system. If your phone is idle
and switched to the secondary system, you'll see a flashing rectangle on the
display. The rectangle remains until the switch to the primary system is
complete.

USING YOUR PHONE

Adjusting the ringer volume

To adjust the Ringer Volume while the set is ringing:
Press the Volume control button.

Adjusting the handset receiver volume

To adjust the Handset Receiver Volume when you are using the
handset:
Press the Volume control button.

Adjusting display contrast

To adjust the contrast level of the display screen while the phone is
not in use::
Press the Volume control button.

Programming the Feature Keys

Programming the feature keys on your 5005 IP phone is done on your
computer using the Desktop Tool to access the 3300 ICP on your network.
Features such as speed dial keys, programming key definitions and Call
Forwarding must be all programmed using the Desktop Tool.
For more information on using the Desktop Tool, please contact your System
Administrator.
-4-