Image Adjustment - Christie LHD700 User Manual

Chapter 4 Controlling the Projector

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.
Item Description
Contrast .............................. Adjusts picture con-
Brightness ......................... Adjusts picture bright-
Color ...................................... Adjusts picture color
Tint ......................................... Adjusts picture hue.
Color temp. ....................... Sets a color temperature
White balance
Red, Green, Blue ..... Adjusts each white
* When changing the value of the
white balance, the color temp.
indicates "Adj."
Offset
Red, Green, Blue ..... Adjusts each offset
Auto picture control ....... Sets auto picture con-
Advanced color ............. Applies improved
Sharpness .......................... Adjusts picture sharpness. (0~ 31)
Gamma .................................. Adjusts brightness of darker part of the picture. (0~ 15)
Noise reduction .............. Switches noise reduction mode (ON, OFF)
Progressive ................................Switches progressive mode (OFF, ON, Film)
Reset...................................... Resets the Image adjustment to previous levels.
Store ...................................... Stores the Image adjustment values. Select an item [Image1 - Image10] from
Load image mode ....... Loads the Image mode. Select an image mode from the pull-down menu and
Input source
Image mode Video Computer
Dynamic
Standard
Natural
Cinema
Real
Image1 - 10
38
trast. (0~ 63)
ness. (0~ 63)
saturation. (0~ 63)
(0~ 63)
mode. (X Low, Low, Mid,
High, Adj.)
balance respectively.
(0~ 63)
respectively. (0~ 63)
trol level. (OFF, L1, L2)
color adjustment with
yellow light controller.
(Auto, OFF)
the pull-down menu and click Store button.
click Load button. There may not be available mode depending on the input
mode as shown in the table left.
4 4
4 4
*
4
*
4
✐ The mark "
*
4
selected input source. The error message appears when
4 4
selecting the disabled image mode indicated with "*".
" means that the available image mode in the
4
020-000446-01 Rev.1 (11-2011)
LHD700 Network User Manual