Returning To The "Server Selection" Screen - NComputing M300 User Manual

Returning to the "Server Selection" Screen

Once a client has connected to a host, there are two ways of returning to the Server Select screen.
Method 1: From the Ncomputing "Press Any Key" splash screen.
Once connected to a server, you can return to the M300 Server Selection screen by doing the
following:
1. Ensure that all three client devices are logged out of their sessions and sitting at the
NComputing "Press Any Key" screen
2. From the Large Client device, press F5
Method 2: From an Auto Connect cycle.
If the M300 devices are configured to automatically connect then pressing F5 will immediately
place you back into the auto connect cycle. You can abort the auto connect cycle and return to
the Server Selection screen by doing the following:
1. From the Large Client, log out of the existing session (if currently logged in) and then
press the ESC key at the NComputing splash screen. This will present a message
directing you to log the two Small Clients out of their sessions.
2. Ensure both Small Clients are logged out.
3. Once both Small Clients are logged out, the Large Client should automatically return to
the Server Selection screen.
NOTE: Tapping ESC can also be used to abort the auto connect cycle prior to connecting to a server.
Page 37 of 78
NComputing M300 User Manual rev.02.21.12