Table of Contents
Advertisement
•
ID Setup
Assigns distinctive IDs to the SET.
•
ID Input
Use to select the transmitter functions of the individual SET. Only a SET where the ID corresponds
to the transmitter setting becomes activated.
•
MDC Connection
Selects a port to receive the MDC inputs from.
•
RS232C MDC : Communicates with the MDC via a RS232C MDC cable.
•
RJ45 MDC : Communicates with the MDC via an RJ45 MDC cable.
•
Network Setting
•
IP Setting : Manual, Auto
•
IP Address : Manually enter the IP Address if IP Setting is set to Manual.
•
Subnet Mask : Manually enter the Subnet Mask if IP Setting is set to Manual.
•
Gateway : Manually enter the Gateway if IP Setting is set to Manual.
MagicInfo
Available Modes
•
PC / DVI / DisplayPort
•
AV
•
Component
•
HDMI
•
MagicInfo
Note
•
MagicInfo can only be enabled when a network box(sold separately) is connected.
•
The remote control can be used to select MagicInfo. However, it is recommended to use a separate
USB keyboard to utilize MagicInfo fully.
Adjusting the LCD Display
Advertisement
Table of Contents
Troubleshooting
