Table of Contents
Advertisement
TROUBLESHOOTING
Most malfunctions are caused by a very minor and easily solved problem. Before contacting your nearest
authorised Service Centre for assistance, consult the troubleshooting chart below.
PROBLEM
• if the
The air-conditioner
does not function
• if the Memo Control pilot lamp is flashing
• if the
• the safety float has switched the appliance off
The air-conditioner
functions for a brief
period only. The
pilot lamp flashes
• the control circuit board is faulty
• the condenser fas has jammed
The appliance
switches on and off
constantly
The air-conditioner
• window open
• source of heat in the room (heater, lamp, etc.)
functions but the
room is not cooled
• the thermostat is set too high
• the air filter is dirty
• the air-conditioner is not powerful enough for
CAUSE
pilot lamp is not lit
- power failure
- the appliance is not plugged in
- less than 3 minutes have passed since the
appliance was last switched off
pilot lamp is lit
- in conditioning mode: the temperature in
the room is already lower than the selected
temperature
because the condensation tray inside the
appliance is full
or the room is very crowded
the size or the conditions of the room
SOLUTION
• wait until the power supply is restored
• insert the plug
• wait three minutes
• slide thermostat slider slowly to the
maximum cooling position
• remove the plug from the drainage
tube and drain the condensation from
the tray.
If this fault persists, contact your
nearest Service Centre.
• contact your nearest Service Centre
• contact your nearest Service Centre
• switch the appliance off and contact
your nearest Service Centre
• close the window
• remove source of heat
• lower the thermostat setting
• clean the filter
25
Hide quick links:
Advertisement
Table of Contents
