Turning On And Selecting Functions; Electrical Connection; Air Conditioning Functions; Delay On Start Up - DeLonghi Pinguino F110 Instructions Manual

F110 4-04-2003 11:10

Turning on and Selecting functions

ELECTRICAL CONNECTION

Before plugging in check that:
• the mains supply corresponds to the
power supply shown on the rating plate;
• the socket and the mains lead correspond
to the power requirements of the applian-
ce;
• the socket is suited to the plug
otherwise have the socket replaced;
• the socket is properly earthed. The manu-
factures cannot be held responsible for
any damages due to failure in following
normal safety procedures.
Replacement of the power cable must be
carried out by qualified personnel.

AIR CONDITIONING FUNCTIONS

The unit is turned off, the function selector
is in the "O" position. To turn the unit on in air
conditioning mode, proceed as follows:
1. Rotate the function selector dial clockwise:
• Place the large star symbol
the reference mark to operate the unit in
air conditioning mode at maximum fan
speed.
• Place the small star symbol
the reference mark to operate the unit in
air conditioning mode at minimum fan
speed.
2. Now set the required temperature by rota-
ting the room thermostat dial
Regulation of the thermostat
The temperature is not expressed in degrees.
We recommend that you turn the thermostat
dial to the maximum position. When the desi-
red room temperature has been reached,
slowly turn the thermostat in a clockwise
direction until it arrives at the position where a
click can be heard. The temperature selec-
ted in this way will automatically be regulated
and maintained, and save energy. When
regulating the thermostat, the air conditio-
ning function is temporarily interrupted and
the unit continues to operate in fan only
mode.
VENTILATION
Rotate the function selector
• Place the large symbol
16
Pagina 16
10 ,
11
in line with
in line with
13 .
anticlockwise.
11
in line with the
reference mark to operate the unit in air puri-
fication mode at maximum fan speed.
• Place the small symbol
reference mark to operate the unit in air puri-
fication mode at minimum fan speed.
TURNING OFF
To turn the unit off completely, set the func-
tion selector to the "O" position and unplug
from the mains
THIS UNIT EMPLOYS AN EXCLUSIVE CON-
DENSATION RECYCLING SYSTEM TO DISPO-
SE OF EXCESS MOISTURE.
IN NORMAL CONDITIONS, CONDENSA-
TION IS DISPOSED OF AUTOMATICALLY.
WHEN THE HUMIDITY IS PARTICULARLY
HIGH, AN EXCESS OF CONDENSATION
MAY BUILT UP IN THE TANK
HAPPENS, THE INDICATOR LIGHT
COMES ON INDICATING THAT THE TANK
SHOULD BE EMPTIED.
ONLY FOR SOME MODEL IN EXTREME CASE
IF THIS PROBLEM IS CURRENT YOU MAY
DISCHARGE THE EXCESS WATER FROM THE
TANK 8 DIRECTLY INTO A DRAIN. USE THE
RUBBER TUBE WITH AN INTERNAL DIAMETER
OF 12 mm. THE TUBE SHOULD BE INSERTED
INTO THE HOLE PROVIDED AFTER REMO-
VING THE RUBBER BUNG MAKE SURE THE
8
TANK . IS PUT BACK CORRECTLY
OTHERWISE THE LIGHT
(SEE FIG. G). THE INTERNAL TANK CAN ALSO
BE DRAINED BY REMOVING THE BUNG FROM
THE DRAIN HOSE
9
INTO A SUITABLE RECEP-
TACLE.

DELAY ON START UP

1 A special safety device will delay the
start of air conditioning by aproximately 3
minutes when switching between func-
tions or on initial start up.
2 You may also experience a slight delay
between changing from one function to
another.
in line with the
8
.. WHEN THIS
.
12
12
. WILL REMAIN ON
G