Table of Contents
Advertisement
S e l e c t i n g f u n c t i o n s
AIR CONDITIONING FUNCTIONS
To turn the unit on in air conditioning mode,
proceed as follows:
1. Press the ON/OFF button
light
will come on).
10
2. Rotate the function selector
counter-clockwise:
• Place the function selector in the HIGH
position to operate the unit in air condi-
tioning mode at maximum fan speed,
after 3 minutes the signal light
come on.
• Place the function selector in the LOW
pos. to operate the unit in air condtioning
mode at minimum fan speed after 3 minu-
tes the signal light
16
3. Now set the required temperature by rota-
ting the room thermostat dial
Note
The temperature is not expressed in degrees.
We recommend that you turn the thermostat
dial to the maximum position. When the desi-
red room temperature has been reached,
slowly turn the thermostat in a clockwise
direction until it arrives at the position where a
click can be heard. The signal lights
16
) will turn off.
The temperature selected in this way will
automatically regulate and maintain the
temperature and save energy. When regula-
ting the thermostat, the air conditioning func-
tion is temporarily interrupted and the unit
continues to operate in fan only mode. In this
way, the appliance keeps the air temperatu-
re within the room constant.
Delay on Start Up
1. A special safety device will delay the start
of air conditionig by approximately 3 to 5
minutes when switching between func-
tions or on initial start up.
2. You may also experience a slight delay
between changing from one function to
another.
10
COOL JET
The cool Jet mode provides the appliance with
greater cooling capabilities. This is particularly
useful when you want to bring the temperatu-
(the signal
11
re of a very warm room quickly down to a more
comfortable level.
In this case:
19
dial
Make sure that the tank is full of water (see
page 8);
Make sure that the function selector switch
will
Press the Cool Jet button
15
tes , the signal light
After reaching the desired temperature, you
can release the Cool Jet button and reposi-
tion the selector switch to the LOW position
This will provided quite operation.
will come on.
20
.
Rotate the function selector
• Press the ON/OFF
• Place the function selector on the "FreshZo-
15
(or
is in the HIGH position.
19
22
21
15
,
or
VENTILATION/FILTRATION
button
light
10
will come on).
ne"
position and choose the desired fan
speed (min/max). The signal light
18
or will come on).
PROBLEM WARNING LIGHT
The pilot light
23
safety device of the pressure switch has swit-
ched on. In this case the appliance is deac-
tivated. To restore the proper functioning of
the appliance, eliminate the possible causes
of the problem and press the restore
button
.
6
The causes may be:
1) Water has accumulated in the exhaust
hose: in this case, it is necessary to drain
the water out of the machine, outwards
(never towards the air conditioner) and
eliminate the water in the hose.
2) The exhaust hose is obstructed: eliminate
the obstacles that obstruct the release of
air to the outside.
If, after having repositioned the drainage tube,
the machine still does not start up, the problem
might be more complicated (ex.: obstructed
ventilation fan) and could require the assistan-
ce of a Delonghi Authorized Service Center.
, after three minu-
16
with come on .
clockwise.
19
11
(the signal
17
indicates that the
Hide quick links:
Advertisement
Table of Contents
