Table of Contents
Advertisement
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST-
MENTS:
•
Depress clutch/brake pedal fully and set parking brake.
•
Place motion control lever in neutral (N) position.
•
Place attachment clutch in "DISENGAGED" position.
•
Turn ignition key to "STOP" and remove key.
•
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TRACTOR
TO REMOVE MOWER (See Fig. X)
Mower will be easier to remove from the right side of tractor.
•
Place attachment clutch in "DISENGAGED" position.
•
Move attachment lift lever forward to lower mower to its
lowest position.
•
Roll belt off engine pulley.
•
Remove small retainer spring, and remove clutch
spring off pulley bolt.
•
Remove large retainer spring, slide collar off and push
housing guide out of bracket.
•
Disconnect anti-swaybar from chassis bracket by re-
moving retainer spring.
•
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
•
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
CLUTCH
SPRING
RETAINER SPRING
ANTI-SWAY BAR
HOUSING GUIDE
LARGE
RETAINER
SPRING
SERVICE AND ADJUSTMENTS
SMALL RETAINER
SPRING
CLUTCH
SPRING
FLAT
WASHER
SUSPENSION ARMS
SMALL
RETAINER
SPRING
BRACKET
COLLAR
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS AND HOOK THE CLUTCH
SPRING INTO SQUARE HOLE IN FRAME.
TO INSTALL MOWER (See Fig. X)
•
Raise attachment lift lever to its highest position.
•
Slide mower under tractor with deflector shield to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Connect front links to mower deck and secure with
retainer springs.
•
Connect suspension arms to rear deck brackets and
secure with retainer springs.
•
Connect anti-swaybar to chassis bracket and secure
with retainer spring.
•
Push clutch cable housing guide into bracket, slide collar
onto guide and secure with large retainer spring.
•
Place flat washer and clutch spring on idler pulley bolt
and secure with small retainer spring.
•
Install belt onto engine pulley.
ENGINE PULLEY
FIG. 16
19
SQUARE HOLE
FRONT LINK
RETAINER SPRINGS
(BOTH SIDES)
DEFLECTOR
SHIELD
Hide quick links:
Advertisement
Table of Contents
