Operating Sequence - Electrolux ESL620 Instruction Book

Operating sequence

1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light comes on.
3. Check that there is salt and
rinse aid
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the dosage quantity
given in the "Washing programmes" chart.
Close the detergent dispenser lid.
7. Set the programme
The selection of the programme occurs with the
door partially opened.
Depress the programme button which
corresponds to the washing programme you
wish to select, the corresponding indicator light
will flash.
8. Start the programme
Close the dishwasher door. An audible signal
advises you that the programme has started.
The indicator light which corresponds to the
programme under way is now permanently on.
9. At the end of the washing
programme
At the end of the programme the dishwasher
will stop automatically and an intermittent
audible signal informs you that the programme
has finished.
The indicator light of the programme will turn off
and the "End of Cycle" indicator light starts
flashing.
The On/Off indicator light remains on until the
"On/Off" push button is depressed.
10. Switch off the dishwasher
Open the door and switch off the dishwasher by
pressing the "On/Off" push button.
Wait a few minutes before removing the dishes;
in this way they will be cooler and the drying will
be improved.
Empty the lower basket first and then the upper
one; this will avoid water dripping from the
upper basket onto the dishes in the lower one.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water tap
turned off.
In general it is not advisable to open the
door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
Important!
Care must be taken if the door is opened
during the hot phase or immediately after a
programme has finished, as steam may
escape.
How to cancel a wash programme
If the door has not been closed and the
wash programme has not started, to cancel
the programme simply press the push button of
a different wash programme.
To change a wash programme in progress,
open the door and press the push button
corresponding to the programme under way for
about 1 second, the relevant indicator light turns
off.
The dishwasher is now reset and you can select
a new programme.
13