Washing Programmes; Operating Sequence - Electrolux ESL499 Instruction Booklet

Operating Sequence

1 Check that the filters are clean
(see cleaning instructions)
2 Depress the ON/OFF pushbutton
The number corresponding to the first selectable
programme appears in the display.
3 Check that there is salt and rinse aid
4 Load the dishes
Remove larger scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
Ensure that the spray arms can rotate freely.
5 Measure out detergent
Pour the required amount of detergent into the dis-
penser according to the indications in the Washing
Programmes chart and close the lid.
6 Set the programme
Press the programme selec-
tor button until the number
corresponding to the re-
quired programme appears
in the display. The pilot light
continues to flash until the
programme is started.
SO78
The following options may also be selected:
- NO DRYING by pressing the relevant button.
The pilot light corresponding to the selection made
comes on.
START
- DELAYED START by pressing the relevant
button until the required number of hours' delay is
set.
7 Starting the wash programme
Open the water tap. Close the dishwasher door. An
audible signal lasting about 1 second informs you that
the programme has been started.
If a delayed start has been selected, the dishwasher
starts the countdown and the number of hours to go
before the programme starts appears in the display.
A flashing dot indicates that the function is active.
Once the set delay has elapsed, the programme
starts automatically. If you wish to interrupt the wash
programme at any time, press the ON/OFF
To restart the machine, press this button again and
the wash programme will resume at the point at which
it was interrupted.
8 At the end of the wash programme
The machine stops automatically. An intermittent audi-
ble signal lasting about 5 seconds informs you that
the programme has finished. A flashing
the display. This signal remains until the programme
selector button is pressed.
Switch of the dishwasher by pressing the ON/OFF
Turn off the water tap.
Wait a few minutes before removing the dishes; in
this way they will be cooler and the drying will be
improved.
Empty the lower basket first and then the upper one;
this will avoid water dripping from the upper basket
onto the dishes in the lower one.
Caution: in general it is not advisable to open the
door while the machine is working; if the door is
opened however, a safety device ensures that the
machine stops.
9 Cancel the wash programme
To cancel a wash programme which is running, press
the «CANCEL» button
accepted» signal (about 2 seconds) is heard. The
number indicating the first selectable programme
appears in the display and the programme selector
light flashes: the previous setting has been cancelled
and a new programme can now be selected.
PSO10GB
12
button.
appears in
until the short «instruction