Daily Use; Before First Use - Electrolux EGL6282NOX User Manual

56 www.electrolux.com

DAILY USE

IGNITION OF THE BURNER
WARNING!
Be very careful when you use open
fire in kitchen environment. Manu-
facturer decline any responsibility in
case misuse of the flame
Always light the burner before you
put cookware.
To light the burner:
1. Turn the control knob counterclock-
wise to the maximum position (
and push it down.
2. Keep the control knob pushed for ap-
proximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and its
cap are in correct positions.
A) Burner cap
B) Burner crown
C)
Ignition candle
D) Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 seconds.
If the burner does not light after 15
seconds, release the control knob,
turn it into off position and try to
light the burner again after mini-
mum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
gas release position.
If the burner accidentally goes out,
turn the control knob to the off po-
sition and try to light the burner
again after minimum 1 minute.
When switching on the mains, after
)
installation or a power cut, it is
quite normal for the spark genera-
tor to be activated automatically.
TURNING THE BURNER OFF
To put the flame out, turn the knob to the
symbol
WARNING!
Always turn the flame down or
switch it off before removing the
pans off the burner.
A
OPERATING ELECTRIC ZONES
B

BEFORE FIRST USE

C
Put on all cooking zones a pan filled with
some water. Set the maximum position
and operate the appliance for approximate-
ly 10 minutes until water inside the pans
D
boils. After that, operate the appliance at
minimum position for 20 minutes. During
this period, an odour and smoke can oc-
cur. This is normal. Make sure that the air-
flow is sufficient.
After this operation, clean the appliance
with a soft cloth soaked in warm water.
To switch on and increase the heat setting
turn the knob counterclockwise. To de-
crease the heat setting turn the knob
clockwise. To switch off turn the knob to
the 0.
Power indicator is activated when electric
cooking zone is turned on, and will stay on
until electric cooking zone is switched off.
.