Electrolux EGL6282NOX User Manual page 53

INSTALLATION
• You must read these instructions.
The manufacturer is not responsible
for any injury to persons and pets or
damage to property caused by fail-
ure to obey these requirements.
• To prevent the risks of structural
damage or physical injury, installa-
tion, connection of the appliance to
the power supply and gas system,
setting up and maintenance must
only be done by qualified personnel
in compliance with standards and lo-
cal regulation force.
• Make sure that the appliance is not dam-
aged because of transport. Do not con-
nect a damaged appliance. If it is neces-
sary, speak to the supplier.
• Only use built-in appliances after you as-
semble the appliance into correct built-in
units and work surfaces that obey the
standards.
• Do not install the hob over a domestic
appliances if the installation instructions
do not allow it.
• Install the appliance only on a worktop
with flat surface.
• Do not change the specifications or
modify this product. There is the risk of
injury and damage to the appliance.
• Fully obey the laws, ordinances, direc-
tives and standards in force in the coun-
try where you use the appliance (safety
regulations, recycling regulations, electri-
cal safety rules etc.)
• Keep the minimum distances to other
appliances and units.
• Install anti-shock protection, for example
install the drawers only with a protective
panel directly below the appliance.
• Prevent damage of the cut surfaces of
the worktop against moisture with a cor-
rect sealant.
• Seal the appliance to the worktop with
no space left with a correct sealant.
• Prevent damage to the bottom of the ap-
pliance from steam and moisture, e.g.
from a dishwasher or oven.
• Do not install the appliance adjacent to
doors and below windows. Hot cook-
ware can be hit off the hob when you
open the doors or windows.
• Before installation, make sure that the lo-
cal supply conditions (gas type and pres-
sure) agree with the adjustment of appli-
ance. The adjustment conditions for the
appliance are on the rating plate, which
you can find near the gas supply pipe.
• This appliance is not connected to a
combustion products evacuation device.
It must be installed and connected in ac-
cordance with current installation regula-
tions. Particular attention must be given
to the relevant requirements regarding
ventilation.
• The use of a gas cooking appliance
cause heat and moisture in the room
in which it is installed. Make sure
that the ventilation in the kitchen is
good: keep natural ventilation holes
open or install a mechanical ventila-
tion device (mechanical extractor
hood).
• More ventilation (for example open-
ing of a window or increasing the
level of mechanical ventilation where
present) is necessary when you op-
erate the appliance with intensity for
a long time.
• Carefully obey the instructions for electri-
cal connections. There is the risk of injury
from electrical current.
• Disconnect the appliance from the
electrical supply, before you do the
maintenance work or you clean it.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Install correctly to give anti-shock pro-
tection.
• A loose and incorrect mains plug and
socket connections can make the termi-
nal become too hot.
• A qualified electrician must install the
clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable
and replace the damaged mains cable
with applicable cable. Speak to your lo-
cal Service Force Centre.
• The appliance must have the electrical
installation which lets you disconnect the
appliance from the mains at all poles
with a contact opening width of mini-
mum 3 mm.
ENGLISH 53