Drain Hose - Electrolux EX401ISB User Manual

117995110 26012007.qxp
33 electrolux installation
Always use a new hose-set when
connecting the appliance to the
water mains. An old hose-set must
not be reused. The inlet hose
should be inspected every 12
months for deterioration and
replaced if necessary.
This appliance has been fitted with
safety features which will prevent the
water used in the appliance from
returning back into the drinking water
system.
Water inlet hose with safety valve
After connecting the double-walled
water inlet hose, the safety valve is
next to the tap. Therefore the water
inlet hose is only under pressure
while the water is running. If the water
inlet hose starts to leak during this
operation, the safety valve cuts off the
running water.
Please take care when installing the
water inlet hose:
●
The electrical cable for the safety
valve is in the double-walled water
inlet hose. Do not immerse the
water inlet hose or the safety valve
in water.
●
If water inlet hose or the safety
valve is damaged, remove the
mains plug immediately.
●
A water inlet hose with safety valve
must only be replaced by a
specialist or by the Customer Care
Centre.
●
Place the water inlet hose in such
a way that it is never higher than
the bottom edge of the safety
valve.
1/27/2007 9:27 AM Page 33
installation electrolux 33
Warning!
Dangerous voltage

Drain hose

- Connect drain hose to the sink.
Secure it with the supplied hose
clamp.
- Required height: 30 to 100 cm
above bottom of the dishwasher.
- If you use a drain hose extension
the total length should not be longer
than 4 metres. Likewise the internal
diameter of the couplings used for
connections to the waste outlet
must be no smaller than the
diameter of the hose provided.
Ensure the hose is not bent or
squashed as this could prevent or
slow down the discharge of water.