Electrolux EVY8740AA User Manual page 21

4. Attach the metal ring to the glass cov-
er.
5. Install the glass cover.
Replacing the lamp on the left side of
the cavity:
1. Remove the left shelf support.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
A
45°
2
B
4.
5.
6.
12.5 Door and glass panels
Remove the door to clean it.
Removing the door
1.
A
2.
3.
4.
5.
To install the door do the above steps in
the opposite sequence.
Removing and cleaning the door
glasses
1
1.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
Install the metal frame and the seal.
Tighten the screws.
Install the left shelf support.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy.
Open the door as far as it goes.
Fully lift up the clamping levers (A) on
the two door hinges.
Close the door until it is at an angle
of approximately 45°.
Hold the door with one hand on each
side and pull it away from the appli-
ance at an upwards angle.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
At this time you can remove the inner
glass panels and clean them.
The door has 2, 3 or 4 panels of
glass (the number depends on the
model).
CAUTION!
Rough handling of the glass, es-
pecially around the edges of the
front panel, can cause the glass to
break.
Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
ENGLISH 21