Related Manuals for Electrolux ESP4SL60CN
Summary of Contents for Electrolux ESP4SL60CN
- Page 1 ESPSL60CN Macchina per caffé automatica Istruzioni per l’uso ESPSL60SP Automatic coffee maker Instructions Machine à café automatique Mode d’emploi Kaffeevollautomat Bedienungsanleitung 801320158 A 272011...
- Page 3 A7 A6...
-
Page 7: Table Of Contents
CONTENTS Changing the quantity of milk....17 Changing the quantity of coffee....17 INTRODUCTION ......7 MAKING A NUMBER OF CUPS OF Symbols used in these instructions ...7 COFFEE WITH THE JUG FUNCTION Letters in brackets........7 (IN PROVIDED)......18 Troubleshooting and repairs.......7 SAFETY ........7 CHANGING JUG FUNCTION Fundamental safety warnings.....7 PARAMETERS ......19... -
Page 8: Introduction
INTRODUCTION working environments; • farm houses; Symbols used in these • by clients in hotels, motels and other resi- instructions dential type environments; • bed and breakfast type environments. Important warnings are identified by these sym- bols. Failure to observe the instructions could re- Danger! This is an electrical appliance, sult in electric shock, serious injury, burns, fire it is therefore important to respect the following... -
Page 9: Designated Use
A7. On-Off/stand-by button Important! Do not use the appliance A8. Control panel when extracted. Make sure the appliance is inac- A9. Water softener filter (not provided with this tive before extracting it. The only exception is ad- model) justing the coffee mill which must be done with A10. -
Page 10: Description Of Milk Container And Accessories
the various modes Connecting the appliance B9. OK icon to confirm the selected function Danger! Check that the mains power B10. icon to deliver a cup of coffee supply voltage corresponds to the value indicated B11. icon to deliver two cups of coffee on the rating plate on the bottom of the ap- B12. -
Page 11: Built-In Installation
BUILT-IN INSTALLATION h 455 mm Verify the minimum measurements required for correct installation of the appliance. The coffee maker must be installed in a column and the column must be firmly fixed to the wall with commercially available brackets. Important: •... - Page 12 x 16 Position the rails on the sides of the cabinet as shown in the figure. Fix with the screws sup- Position the appliance on the rails, making sure plied, then extract them completely. If the coffee the pins are correctly inserted in the housings, maker is installed over a warmer drawer, use the then fix it with the screws supplied.
-
Page 13: Using The Appliance For The First Time
USING THE APPLIANCE N.B.! When using the appliance for the first time, you need to make 4-5 cups of coffee FOR THE FIRST TIME and 4-5 cappuccinos before the appliance gives satisfactory results. • Coffee has been used to factory test the ap- pliance and it is therefore completely normal N.B.! Each time you turn the coffee maker for there to be traces of coffee in the mill. -
Page 14: Replacing The Filter ("Filter Reset")
CONFIRM" is displayed. Removing the filter 11. Press the OK icon (B9) to confirm the selec- To use the appliance without a filter, you must re- tion (or ESC (B6) to cancel). "HOT WATER move it and notify the appliance of its removal as PRESS OK"... -
Page 15: Making Coffee Using Coffee Beans
MAKING COFFEE USING • Preheat the cups by rinsing them with hot water. COFFEE BEANS NOTE 4: Coffee delivery can be interrupted at any moment by re-pressing the previously selected 1. The appliance is preset to make coffee with a icon which remains lit during the operation. -
Page 16: Changing The Quantity Of Coffee In The Cup
OK" and then "FILL TANK!". Check the level of • Press the OK icon (B9) again to confirm (or water in the tank and replace in the appliance. the ESC icon (B6) to cancel the operation). To use the appliance again, insert the hot water •... -
Page 17: Delivering Hot Water
fee, to go back to making coffee using beans, (B8) (fig. 2) until "PROGRAM HOT WATER" deactivate the pre-ground coffee function by is displayed. pressing the icon (B4) (fig. 8). • Press the OK icon (B9) to confirm. NOTE 1: Never introduce pre-ground coffee when •... -
Page 18: Changing The Quantity Of Milk And Coffee For Cappuccino
After cleaning, remove the milk container and NO froth place in the refrigerator. The milk should not be left out of the refrigerator for more than "Denser" froth 15 minutes. NOTE 4: To change the quantity of coffee or fro- thed milk the appliance delivers automatically frothed milk into the cup, proceed as described in the section... -
Page 19: Making A Number Of Cups Of Coffee With The Jug Function
• Press the OK icon (B9) again. • Press the OK icon (B9). • Select the quantity of coffee required by pres- The type of coffee selected, for example sing the icons (B7) and (B8). "EXTRA-MILD JUG", and the number of cups The progress bar shows the quantity of cof- you want to make with the jug are displayed, fee selected. -
Page 20: Changing Jug Function Parameters
CHANGING JUG FUNCTION CLEANING PARAMETERS (if provided) Cleaning the coffee maker Do not use solvents or abrasive detergents to The jug programme is factory set with default va- clean the coffee maker. A soft damp cloth will suf- lues. fice. These can be modified to suit your personal taste Never wash any of the components of the coffee and saved. -
Page 21: Cleaning The Water Tank
3. Clean the drip tray and waste coffee container (A4). Important! The brewing unit (A5) must 4. Replace the drip tray and waste coffee con- not be removed when the appliance is on. Do not tainer (A4). use force to remove the brewing unit. 5. -
Page 22: Cleaning The Milk Container
have snapped out. dues left inside the holes and the groove on the fine end of the frothed milk regulator. 5. Check that the intake tube and spout are not clogged with milk residues. 6. Replace the frothed milk regulator, milk spout and intake tube. -
Page 23: Rinsing
• Press the icon (B2) to enter the menu. • Press the icon (B2) to enter the menu "CHOOSE LANGUAGE" is displayed. and then the icons (B7) and (B8) until • Press the OK icon (B9). "SHUT-OFF TIME" is displayed. •... -
Page 24: Setting Water Hardness
splays the message “START TIME” (AUTO Programming coffee START-UP). Press the OK (B9) icon. “CON- For instructions on programming coffee, see the FIRM” will appear on the display. Press "ESC" "CHANGING THE QUANTITY OF COFFEE IN THE to deactivate and the symbol will di- CUP"... -
Page 25: Resetting Default Values (Reset)
the descaler bottle into the tank respecting • Press the OK icon (B9) to reset the default the instructions given on the descaler pack, values. then add water up to the MAX level marked Statistics on the water tank. Position a container with a capacity of about This displays statistics relating to the machine. -
Page 26: Water Filter
• Press the ESC icon (B6) once to exit the fun- ELECTRICAL CONNECTION ction or twice to exit the menu. (UK ONLY) Water filter A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your For instructions on the water softener filter, see the socket, the plug should be cut off from the mains section "INSTALLING THE FILTER". -
Page 27: Displayed Messages
DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL TANK • The water tank is empty or • Fill the tank with water positioned incorrectly. and/or insert it correctly, pushing it as far as it will GROUND TOO FINE ADJUST • The grinding is too fine •... - Page 28 DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY • The "pre-ground coffee" • Extract the appliance and ADD PRE-GROUND COFFEE function has been selec- place pre-ground coffee in ted without placing any the funnel. pre-ground coffee in the funnel. • The funnel (A21) is bloc- •...
-
Page 29: Troubleshooting
TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot • The cups were not pre- • Warm the cups by rinsing heated. - Page 30 PROBLEM POSSIBLE CAUSE REMEDY The coffee is delivered too • The coffee is ground too • Turn the grinding adju- quickly. coarsely. stment knob one click an- ticlockwise towards "1" while the coffee mill is in operation (fig. 14). Avoid turning the grinding adjustment knob excessi- vely otherwise when you select 2 cups, the coffee...
- Page 31 PROBLEM POSSIBLE CAUSE REMEDY Water comes out of the • The pre-ground coffee • Clean the funnel (A21) spouts instead of coffee. may be blocked in the fun- with a wooden or plastic nel (A21). fork, clean the inside of the appliance.
- Page 32 5713217631/11.11...