Installation Instructions; Before Installation; After Installation - Electrolux EMC38905X User Manual

Installation instructions

Before installation

Check that the input voltage indicated on the
characteristics plate is the same as the voltage of
the power outlet you are going to use.
Open the oven door and take out all the
accessories and remove the packing material,
including the white polystyrene part that holds the
turntable plate.
Do not remove the mica cover on the ceiling of the
interior! This cover stops fat and pieces of food
damaging the microwave generator.
Warning! The front surface of the oven may be
wrapped with a protective film. Before using the
oven for the first time, carefully remove this film,
starting on the inside.
Make sure that the oven is not damaged in any
way. Check that the oven door closes correctly and
that the interior of the door and the front of the oven
opening are not damaged. If you find any damage
contact the Technical Assistance Service.
DO NOT USE THE OVEN if the power cable or the
plug are damaged, if the oven does not function
correctly or if it has been damaged or dropped.
Contact the Technical Assistance Service.
Put the oven on a flat and stable surface. The oven
must not be put close to any sources of heat, radios
or televisions.
During installation, make sure that the power
cable does not come into contact with any
moisture or objects with sharp edges behind the
oven. High temperatures can damage the cable.
Warning: after the oven is installed you must
make sure you can access the isolating switch.
Electrical Installation
Electrical installation must be performed by an
electrician qualified
legislation in force.
Before connecting the microwave oven to the
electric mains, check that the voltage and frequency
of the mains matches that which is shown on the
rating plate located in the cavity front, and on the
guarantee certificate, which should be kept together
with this manual.
During installation, follow the instructions supplied separately.
in accordance with
The electric connection is made via an omnipolar
switch, which is suitable for the intensity to be
tolerated and which has a minimum gap of 3mm
between its contacts, to ensure disconnection in
case of emergency or when cleaning the microwave.
If a plug is used for the electric connection then it
must be accessible after installation.
The connection should include correct earthing, in
compliance with current norms. WARNING: THE
OVEN MUST BE EARTHED.
If the flexible supply cable fitted to the microwave
ever needs to be changed, it should be replaced by
an official After Sales Service, because it requires
special tools.
The manufacturer and retailers do not accept
responsibility for any damage that may be caused
to people, animals or property if these installation
instructions are not observed.

After installation

The oven only functions when the door is closed
correctly.
After the first use, clean the inside of the oven and
the accessories, following the cleaning instructions
given in the
maintenance".
Fit the Turntable support (1) in the centre of the
oven cavity and put the Turntable ring (2) and the
Turntable plate (3) on top, making sure they slot in.
Whenever you use the microwave, the turntable
plate and the respective accessories must be inside
and correctly fitted. The turntable plate can rotate
in both directions.
the
4
section "Oven cleaning
EN
and