Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION
Check that the input voltage indicated
on the characteristics plate is the same
as the voltage of the power outlet you
are going to use.
Open the oven door and take out all
the accessories and remove the
packing material.
Do not remove the mica cover on the
ceiling of the interior! This cover stops
fat and pieces of food damaging the
microwave generator.
WARNING!
The front surface of the oven may
be wrapped with a protective film.
Before using the oven for the first
time, carefully remove this film,
starting on the inside.
Make sure that the oven is
not damaged in any way.
Check that the oven door
closes correctly and that the
interior of the door and the
front of the oven opening are
not damaged. If you find any
damage contact the
Technical Assistance
Service.
DO NOT USE THE OVEN if the power
cable or the plug are damaged, if the
oven does not function correctly or if it
has been damaged or dropped,
contact the Technical Assistance
Service.
Put the oven on a flat and stable
surface. The oven must not be put
close to any sources of heat, radios or
televisions.
During installation, make sure that the
power cable does not come into
contact with any moisture or objects
with sharp edges behind the oven.
High temperatures can damage the
cable.
AFTER INSTALLATION
The oven is equipped with a power
cable and a plug for single phase
current.
If the oven is to be installed on a
permanent basis it should be installed
by a qualified technician. In such a
case, the oven should be connected to
a circuit with an all-pole circuit breaker
with a minimum separation of 3 mm
between contacts.
WARNING: THE OVEN MUST
BE EARTHED.
The manufacturer and retailers do not
accept responsibility for any damage
that may be caused to people, animals
or property if these installation
instructions are not observed.
The oven only functions when the door
is closed correctly.
After the first use, clean the inside of
the oven and the accessories,
following the cleaning instructions
given in the section "Oven cleaning
and maintenance".
Fit the Turntable support in the centre
of the oven cavity and put the
Turntable ring and the Turntable plate
on top, making sure they slot in.
Whenever you use the microwave, the
turntable plate and the respective
accessories must be inside and
correctly fitted. The turntable plate can
rotate in both directions.
During installation, follow the
instructions supplied separately.
ENGLISH 3
Hide quick links:
Advertisement
Table of Contents
