Installation; To Adjust Plinth Height And Depth - Electrolux EKE 6160 Instruction Book

Installation

Installation
Work on the cooker must be carried out by
QUALIFIED ELECTRICIAN
Certain edges and corners which will not nor-
mally be exposed may be sharp.
moving the cooker.
Before installing the cooker, you should check that its
dimensions correspond to the rest of your kitchen
units. Measure the height of the worktop from floor to
top surface of the worktop, and the plinth depth from
the wall to the front edge of the plinth (see illustra-
tion). The cooker may also be installed adjoining one
wall or one tall unit on one side, and a worktop on the
other side.
When delivered, the cooker plinth is adjusted to suit a
worktop height of 90 cm and a plinth depth of 53 cm.
You can alter the height and depth of the plinth to make
the cooker suitable for a worktop height of 85, 88 or 90
cm and a plinth depth of 55 cm (see below).
Check the cooker cable is not trapped when moving
the cooker.

To adjust plinth height and depth

53 cm is the minimum plinth depth for this
cooker. Setting a smaller plinth depth can cause
the cooker to tip if a heavy weight is placed on
the door.
If you wish to alter both dimensions, you should adjust
both at the same time. But make sure you read through
the full instructions before starting work.
Carefully lay the cooker on its back
1
. Use some of the packaging material to
)
STRATION
cushion the cooker on the floor surface.
Unscrew the four screws
2
If you are altering the cooker height only, pull
the inner plinth out a certain distance. Grasp the
brackets which hold the wheels and feet.
Be careful, there are sharp edges under the
!
NOTE
cooker. Go to point 5 and continue from there. If
altering the plinth depth, you should pull the
plinth completely out.
Unscrew the four screws
3
Then remove the outer plinth.
Position the outer plinth at the 55 cm setting
4
(
SEE ILLUSTRATION
24
. The cooker is heavy.
USE GLOVES
(
SEE ILLU
, see the illustration.
(A)
, see the illustration.
(B)
. Screw in the screws
B) (B)
A
when
-
90
88
53
85
55