Pioneer AVIC-Z150BH Operation Manual page 156

Chapter
27 Customizing preferences
Do not press the h button to open or close
the panel when you are using the micro-
phone.
1 Stop the vehicle in a quiet place, close
all the doors, windows and sun roof, and
then turn the engine off.
If the engine is left running, engine noise may
prevent correct Auto EQ.
p If driving restrictions are detected during
measurement, measurement is canceled.
2 Fix the microphone for acoustical mea-
surement (sold separately) in the center of
the headrest of the driver's seat, facing for-
ward.
The Auto EQ may differ depending on where
you place the microphone. If desired, place
the microphone on the front passenger seat
and perform Auto EQ.
3 Disconnect the iPhone or smartphone
device.
4 Turn on the ignition switch (ACC ON).
If the vehicle s air conditioner or heater is
turned on, turn it off. Noise from the fan in the
air conditioner or heater may prevent correct
Auto EQ.
Switch the AV source to "Off".
5
= For details of the operations, refer to Dis-
playing the AV operation screen on page 71.
6 Set the video setting for the rear dis-
play to "Mirror AV".
= For details of the operations, refer to Select-
ing the video for rear display on page 159.
156
En
7 Press the HOME button to display the
"Top Menu" screen.
8 Touch .
The Edit/Settings screen appears.
9 Touch [AV Settings].
The AV Settings menu appears.
10 Touch [Auto EQ Measurement].
The Auto EQ Measurement screen ap-
pears.
11 Plug the microphone into the mini-jack
connector.
Mini-jack of the RCA connector
Microphone for acoustical measurement (sold separately)
12 Touch [Start].
A 10-second countdown starts.
13 Exit the vehicle and keep the door
closed until the countdown finishes.
When the countdown is over, a measurement
tone (noise) is emitted from the speakers and
the Auto EQ measurement begins.
14 Wait until the measurement is com-
pleted.
When Auto EQ is completed, a message is dis-
played indicating that the measurement is
completed.
p If the vehicle s acoustics cannot be mea-
sured correctly, an error message will be
displayed.
p The measurement time varies depending
on the type of vehicle.
p To stop the measurement, touch [Stop].