Use Of The Appliance; Set The Water Softener - Electrolux ESL2450 User Manual

This function is available with all washing pro-
grammes. The related indicator light comes
on when you press the button.
The save energy function has no effect on
some programmes. Refer to the chapter
'Washing programmes' for the list of pro-
grammes where save energy has or not an
effect.
Function buttons
Use the function buttons for these opera-
tions:
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the audible signals.
Refer to the section 'Audible signals'.
• To cancel the washing programme in pro-
gress or a delay start in progress. Refer to
the chapter 'Setting and starting a washing
programme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water
softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.

Use of the appliance

Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.

Set the water softener

The water softener removes minerals and
salts from the water supply. Minerals and
4. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
flashes.
– The digital display shows the setting.
The audible signals are activated.
5. Press the function button C again.
– The digital display shows the new set-
ting.
The audible signals are deactivated.
6. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the digital
display shows necessary setting.
Setting mode
The appliance is in setting mode when all the
programme indicator lights are on.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel
the programme to go back to the setting
mode. Refer to the chapter "Setting and
starting a washing programme".
5. Set the correct washing programme for
the type of load and soil.
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing programme.
If you use detergent tablets, refer to the
chapter 'Use of detergent'.
salts can have bad effect on the operation of
the appliance.
electrolux 5
Audible sig-
nals deactiva-
ted
Audible sig-
nals activated