Electrical Connection; Stacking Kit; Door Reversal - Electrolux EDE420E Instruction Booklet

125980060.qxp 2004.07.28 09:27
It is important not to connect the
venthose to, for example, a cooker
hood, or a chimney or flue pipe
designed to carry the exhaust from a
fuel burning appliance.
Note that to avoid condensation problems, it is
essential that the dryer is fitted with the flexible
hose to carry its "exhaust" at least beyond the
kitchen units; preferably outside the kitchen.
In order to prevent the appliance from overheating,
it is important that the steam exhaust is obstructed.
Therefore, in case of a permanent hose fitted to an
exterior wall or ceiling, it must be ensured an
exhaust capacity of at least 150 m
If the dryer is fitted next to kitchen units, make
sure that the vent hose is not squashed. If the
hose is partially squashed, drying efficiency
will be reduced, resulting in longer drying times
and higher energy consumption.
If the hose is completely squashed, the safety
cut outs with which the machine is fitted may
operate.

Electrical connection

This machine is designed to operate on a 220 240 V,
single phase, 50 Hz supply.
Check that your domestic electrical installation can
take the maximum load required (2.2 kW), also
taking into account any other appliances in use.
Connect the machine to an earthed socket, in
accordance with current wiring regulations.
CAUTION: If the appliance is supplied with a cord
extension set or an electrical portable outlet such a
device, must be positioned so that it is not subject
to splashing or increase of moisture.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution.
Page 8
3 /h.
8

Stacking kit

A special stacking kit is available through your
dealer, to mount the dryer on top of your front
loading Electrolux washing machine.

Door reversal

To make it easier to load or unload the laundry the
door can be reversed.
This operation must be carried out by qualified
personnel.
Operate as follows:
Remove the door by unscrewing the two screws
(1) fastening the hinge to the cabinet (Fig. A).
Remove the safety catch (2) and the plug (3) by
bending the two fastening tags (Fig. A).
Refit the safety catch (2) and plug (3) on the door
by reversing their positions (Fig. B).
Remove the plastic plate (4) by unscrewing the
two fastening screws (Fig. A).
Refit the plastic plate (4) on the opposite side
(Fig. B).
Refit the door by screwing in the two screws (1)
which fasten the door to the cabinet (Fig. B).