Electrolux EHET66CS User Manual page 7

Multi-purpose zone
To switch off outside ring
Switching the STOP+GO function on and off
The STOP+GO function simultaneously switches all cooking zones that are switched on to
the keep warm setting and then back to the heat setting that was previously set.
Timer functions are not stopped by
STOP+GO.
To switch on
To switch off
Locking/unlocking the control panel
The control panel, with the exception of the "On/Off" sensor field, can be locked at any time
to prevent the change of settings.
Switch on
Switch off
When you switch the appliance off, the
locking function is automatically switch-
ed off.
Using the automatic warm-up function
All cooking zones are equipped with an automatic warm up function
setting using and starting from
amount of time and then automatically switches back to the heat setting set.
Switch on (only when starting
at )
Switch off
Not used
If during the automatic warm up
higher heat setting is selected, e.g.
from to , the automatic warm up
is adjusted.
The length of time that the automatic warm up function operates depends on the
heat setting selected.
Heat setting
Sensor field
Touch for 1-2 seconds
Control panel
Touch
Touch
Control panel
Touch
Touch
, the cooking zone switches to full power for a certain
Control panel
Touch
Touch
Touch
a
Length of the automatic warm up [min:sec]
goes out
STOP+GO locks the whole control
panel except the sensor field .
previously set heat setting
(for 5 seconds)
previously set heat setting
Possible heat set-
tings
to
to /
to
If there is still residual heat on the
cooking zone (display
matic warm up is not performed.
0:30
1:00
1:40
4:50
6:30
electrolux 7
Pilot light
Display
Display
. When setting a heat
Display
(after 5 seconds)
to
to
), the auto-