Advertisement
This product is not designed for continuous use. In the case of continuous
use, the lamp's lifetime will shorten. Please replace the lamp when you meet
these problems.
The lamp burn out, but other parts are normal.
The image becomes darker or unclear.
If above phenomenon has occurred, we suggest you replace the old
lamp as soon as possible.
Operation:
1. Before replacing the lamp, turn the projector off and unplug the power cord,
and then wait at least 45 minutes for the lamp to cool sufficiently.
2. Turn it over, and put it on the projector, loose the 4 screws of the cover of
lamp garage, then open it.
3. Loose the 3 screws fixed inside cover, then lift the cover forward and pick it
up.
4. You can see the bulb is blocked in the white lamp stand, push one of bulb's
end lightly and take it out. (The protruding in the stand blocks the bulb). Do
not loosen the fixed screws on the stand. Prevent the bulb deviating from
the centre.
5. After picking the old lamp out, you can put the new one's end into the white
stand and push it lightly into the stand.
6. Back to the 3
projector over.
7. When you insert the lamp into the stand, please keep the vent of the lamp
forward.
16
rd
nd
and 2
step, and tweak the fixed screws. At last, put the
Advertisement
