Advertisement
Please turn off the power of the projector and signal before connecting a
VGA source while the power is on may result in operational errors.
Please confirm the type of
projector can be damaged if the wrong connector is inserted.
Set projector to the "VGA" by using the button "PC/ AV".
Refer to the VGA source manual to configure the source resolution and
frequency.
Connect audio and video output sources to the corresponding input
connections located on the side of the projector.
To select the AV source use the mode button on supplied remote or press
the PC/AV button located on the top of the projector until AV is select.
Video output and left/right audio output of signal source should connect
with corresponding input ports located on the side of the projector.
1. Remove the rear cover
2. Load the batteries as indicated by the marks in the battery
compartment .
3. Put the rear cover back on
connector fits the inpu
t on the projector, the
5
Advertisement
