Hob - Daily Use - Electrolux EKG4120AOW User Manual

Hide thumbs Also See for EKG4120AOW:
Table of Contents

Advertisement

5. HOB - DAILY USE

WARNING!
Refer to the Safety chapters.
5.1 Lighting the burners
WARNING!
Be very careful when you use
open fire in a kitchen environment.
The manufacturer declines all re-
sponsibility in case of misuse of
the flame.
Always light the burner before you
put cookware on it.
1.
Turn the knob to the maximum posi-
tion
push the knob, the spark generator
activates automatically.
2.
Keep the control knob pushed for ap-
proximately 5 seconds. This lets the
thermocouple warm up. If not, the
gas supply is interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in the correct positions.
9
8
7
6
Burner cap
1
Burner crown
2
Ignition candle
3
Thermocouple
4
Hob
5
Slots
6
Burner body
7
Location peg
8
Hole
9
and push it down. When you
5.2 Replacing burner parts
1.
Carefully put the burner crown on the
burner body. Do not use force.
a)
Make sure that the hole in the
crown is above the ignition can-
dle.
b)
Make sure that the location pegs
are in the slots in the burner
body.
c)
Let the crown fall freely onto the
body.
d)
Make sure that you can move the
crown a small distance from side
to side.
2.
Put the burner cap centrally on top of
the crown (enamel side up). Move the
cap from side to side and front to
back to make sure that it is correctly
installed.
3.
Try to light the burner. If the burner
does not ignite, adjust the crown and
cap again.
WARNING!
Do not keep control knob pressed
for more than 15 seconds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
1
wait for at least 1 minute before
trying to light the burner again.
2
If the burner accidentally goes out,
3
turn the control knob to the off
position and try to light the burner
4
again after minimum 1 minute.
5
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
5.3 Turning the burner off
To put the flame out, turn the knob to the
symbol
WARNING!
Always turn the flame down or
switch it off before you remove the
pans from the burner.
ENGLISH
.
9

Advertisement

Table of Contents
loading

Table of Contents