Grounding Instructions; Safety And Compliance; Installation Instructions; Installation Tools And Requirements - GE WattStation Wall Mount User Manual

WattStation Wall Mount User Manual

1. Grounding Instructions

1.1

Safety and Compliance

Read all instructions before using this product.
Do not use this product if the flexible power cord or charging cable are frayed, have
broken insulation, or any other signs of damage.
Do not use this product if the enclosure or the charging connector are broken, cracked,
open, or show any other indication of damage.
This document provides instructions for the wall mounted WattStation and should not be
used for any other product. Before installing WattStation you should review this manual
carefully and consult with a licensed contractor, licensed electrician, or trained
installation expert to ensure compliance with local building codes, climate conditions,
safety standards and state and local electrical codes.
1.2 Grounding Instructions
WattStation must be connected to a centrally grounded electrical system. Ground
conductors entering WattStation must be connected to the equipment grounding bar
inside the charger. Connections to WattStation shall comply with all applicable electrical
codes and ordinances.

2. Installation Instructions

2.1

Installation Tools and Requirements

Recommended Tools:
 Slotted screwdriver (3/16" or
Electric drill

 Wire stripper
Wall mounting hardware (refer to section 2.2.1 or section 2.3.1)

 Phillip's head screwdriver
Water-tight conduit hub (hardwired version only)

3
")
GE Energy ©2011 GE Company All Right Reserved