Plug-In Version; Before Installation - GE WattStation Wall Mount User Manual

WattStation Wall Mount User Manual
Torque Specification Table:
COMPONENT
M5 x 0.8 screw
#12 thread-cutting screw
10-32 UNF screw
6-32 UNC screw
Fuse block lugs
Field wiring lugs
Din-rail mounted terminal block lugs
Contactor lugs
Ground bar lugs
M3 x 0.5 screw
#8 thread cutting screw
3/4" cable strain relief fitting
2.2

Plug-in Version

2.2.1

Before Installation

WattStation should be installed only by a licensed contractor, and/or a
licensed electrician in accordance with all applicable state, local and
national electrical codes and standards.
Ensure that a dedicated circuit, capable of supplying 30A at 208-240 VAC,
•
is available
Power feed must have a centrally grounded neutral in order for WattStation to
•
function correctly.
Wall receptacle must be a NEMA 6-50 outlet. A recommended 40A upstream
•
circuit breaker, located either in a panelboard or load center, should be used
Distance between the wall power receptacle and WattStation mounting should
•
be less than one (1) foot
Wall power receptacle with a weatherproof locking cover is required
•
Recommended mounting hardware for wood studs are 3/8" x 2" hex head lag
•
bolts. Recommended mounting hardware for concrete walls are 3/8" x 1-3/4"
concrete hex screws or 3/8" x 1-7/8" concrete anchors
WARNING: Danger of electrical shock or injury. Turn
OFF power at the panelboard or load center before
working inside the equipment or removing any
component
devices or any other component until the power is
turned OFF.
4
.
Do not remove circuit protective
GE Energy
TORQUE VALUE
30 in-lb
30 in-lb
35 in-lb
12 in-lb
45 in-lb
50 in-lb
12 in-lb
50 in-lb
35 in-lb
12 in-lb
30 in-ib
Hand-Tight + 1/4 turn
©2011 GE Company All Right Reserved
TOLERANCE
+/- 2 in-lb
+/- 2 in-lb
+/- 5 in-lb
+/- 2 in-lb
+/- 2 in-lb
+/- 2 in-lb
+/- 2 in-lb
+/- 2 in-lb
+/- 2 in-lb
+/- 2 in-lb
+/- 2 in-lb
N/A