Electrolux EP3003011 User Manual page 25

Pyrolytic cleaning
Remove all parts from the oven.
Do not start the pyrolytic cleaning if:
• If you do not remove the shelf support or telescopic shelf runners (if supplied) - the
display shows 'C1' on some models.
• if you do not close the oven door correctly- the display shows 'C3' on some models.
1. Remove the worst of the residual dirt manually.
2. Set the Pyrolytic cleaning function (refer to section "Oven functions").
3. flashes.
After 2 seconds procedure starts. The procedure is 1 h 30 min long.
You can use the End function to delay start of the cleaning process.
When the oven reaches pre-set temperature, the door locks. The symbol
of the heat indicator come up, until the door unlocks again.
During pyrolytic cleaning the lamp is off.
Cleaning reminder
To remind you that the pyrolytic cleaning is necessary the cleaning reminder symbol flash-
es in the display PYR after every activating and deactivating the appliance for the next
10 seconds.
The cleaning reminder goes off the display:
• after end of the pyrolytic cleaning function;
• if you use
Shelf support
You can remove the shelf support to clean the side walls.
Removing the shelf support
1. Pull the front of the shelf support away
from the side wall.
or , when is flashing;
Care and cleaning
and the bars
25