Table of Contents
Advertisement
10 www.electrolux.com
7.1 Using the detergent
A
7.2 Using the combi detergent
tablets
When you use tablets, that contain salt
and rinse aid, do not fill the salt container
and the rinse aid dispenser. The rinse aid
indicator always comes on if the rinse aid
dispenser is empty.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the low-
est position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.
B
30
A
20
+
-
C
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compartment
(A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
7.3 Setting and starting a
programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation, all the programme in-
dicators are off and the end indicator
flashes.
If the control panel shows other condi-
tions, press and hold the programme but-
ton until the appliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Press continuously the programme
button until the indicator of the pro-
gramme you want to set comes on.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button to delay the
start of the programme of 3 hours.
The delay indicator comes on.
3. Close the appliance door. The count-
down starts.
Advertisement
Table of Contents
