Installation - Electrolux Chef CKG5060W Instruction Book

Installation

Important
Qualified personnel must install
this cooker. The manufacturer will
not accept liability, should the
above instructions or any of the
other safety
incorporated
ignored.
Regulations
This appliance shall be installed in
accordance with the manufacturer's
installation instructions, local gas
fitting regulations,
building codes, AS5601 (AG601)
and any other relevant statutory
regulations.
Rating label
The rating label is located on the
lower front frame of the cooker upon
opening the door. This appliance is
suitable for Natural and Universal
LPG. Ensure that the gas supply
matches the rating label. A duplicate
data label has been supplied with
this appliance,
attached to readily available adjacent
surface on installation.
Ventilation
Ventilation must be in accordance
with AS5601 (AG601) Installation
Code. In general, the appliance
should have adequate ventilation
for complete combustion of gas
and to maintain temperature of
immediate surroundings within safe
limits.
instructions
in this book
municipal
which must
Connection to the gas supply
Gas connection must be carried out
by a licensed gas fitter and in
conformity with the regulations in
force. The appliance leaves the factory
tested and regulated for the type of
be gas indicated on the plate, which is
situated in the lower position near
the gas connection tube.
Ascertain that the type of gas with
which the appliance will be supplied
is the same as that indicated on the
plate.
If different carry out all the operations
according to the indications cited in
the paragraph "adaptation of different
types of gas".
For a maximum output and minimum
consumption
pressure of the gas used the values
indicated in the table of "burners
characteristics".
The joint is mounted on the intake
area of the pipe, fitted with a filleted
nut G1/2", between the sealing
components. Screw the parts without
be forcing, turn the joint in the direction
required and then tighten everything.
ascertain that the
11