Electrolux Chef CKG5060W Instruction Book page 10

Draw a line on the wall – after
leveling the cooker – along the top
edge of the hob (see illustration).
The measurements shown can be
applied when the non-tip device is
fitted on the left (see illustration).
Measure and mark where the non-tip
device is to be placed. Attach the
bracket to the wall with the fixings
that are recommended for your wall
type and then check that the bracket
is secure enough to hold the cooker
in place with weight applied to the
open cooker door.
Due to the large range of wall types
and different fixings required for each
type, the fixings are not supplied, so
the appropriate fixings should be
obtained from a hardware store.
NOTE! If the space between
kitchen units is wider than the
cooker, you will need to alter the
measurements shown in the
illustration if the cooker is to be
centered.
If you alter the measurements,
remember to align the cooker correctly
when pushing it into place, so that
the non-tip device enters the hole on
the cooker rear.
10