Pro-Form 425 CT User Manual page 11

8. Identify the Right Upright Cover (86) and the
Right Handrail (83). Slide the Right Upright
Cover onto the Right Upright (85). Remove the
tie from the bracket on the Right Handrail. If
necessary, press the 5/16" Cage Nut (38) back
into place.
Hold the Right Handrail (83) near the Right
Upright (85). Insert the Upright Wire (87) through
the bracket on the bottom of the Right Handrail,
and pull the Upright Wire out of the end of the
Right Handrail.
Attach the Right Handrail (83) to the Right
Upright (85) with two 5/16" x 1" Screws (3) and a
5/16" x 1" Bolt (4) with a 5/16" Star Washer (13);
do not tighten the Screws and the Bolt yet.
Attach the Left Upright Cover (not shown)
and the Left Handrail (not shown) in the
same way. Note: There is no wire on the left
side.
9. Set the console assembly face down on a soft
surface to avoid scratching the console
assembly.
Remove the screws (A) and the two ties (B)
attaching the Crossbar (104). Next, lift off the
Crossbar. Discard the screws and the ties.
8
Bracket
3
83
9
A
Console
Assembly
B
11
87
38
13
86
B
104
4
85