Abit NF8 Pro User Manual page 38

3-12
CAS# latency (Tcl):
Leave this item to its default [Auto] setting.
RAS# to CAS# delay (Trcd):
Leave this item to its default [Auto] setting.
Min RAS# active time (Tras):
Leave this item to its default [Auto] setting.
Row precharge Time (Trp):
Leave this item to its default [Auto] setting.
# Back to Advanced Chipset Features Setup Menu:
AGP Aperture Size:
This option specifies the amount of system memory that can be used by the AGP device. The aperture is a
portion of the PCI memory address range dedicated for graphics memory address space.
(AGP 3.0 Mode) AGP 2.0 Mode:
This item selects the data transfer rate of AGP device. A higher rate delivers faster and better graphics to
your system. Make sure your graphics card supports the mode you select. Leave this item to its default
[Auto] setting.
AGP Fast Write:
Leave this item to its default [Auto] setting.
AGP Sideband Address:
Leave this item to its default [Auto] setting.
Special I/O for PCI Card:
This item allows you to assign specific I/O address for add-on PCI card.
! Base I/O Address:
This item assigns the specific I/O address for the PCI card.
! I/O Length:
This item configures the I/O length for the PCI card.
Init Display First:
This item selects to initialize AGP or PCI Slot first when the system boots.
[PCI Slot]: When the system boots, it will first initialize PCI.
[AGP]: When the system boots, it will first initialize AGP.
System BIOS Cacheable:
Two options are available: Disabled or Enabled. When you select Enabled, you get faster system BIOS
executing speed via the L2 cache.
NF8 Series
Chapter 3