Floppy Disk Drive Connector - Abit IS7-G User Manual

Hardware Setup

(13). Floppy Disk Drive Connector

This connector supports two standard floppy disk drives via a 34-pin 34-conductor ribbon cable.
Connecting the Floppy Disk Drive Cable:
1. Install one end of the ribbon cable into the FDC1 connector. The colored edge of the ribbon cable
should be aligned with pin-1 of FDC1 connector.
2. Install the other end(s) of ribbon cable into the disk drive connector(s). The colored edge of the
ribbon cable should be also aligned with pin-1 of disk drive connector. The endmost connector
should be attached to the drive designated as Drive A.
IS7-G/IS7/IS7-E:
IS7-M: IS7-E2:
IS7-M/IS7-E2/IS7-V2:
IS7-V2:
User's Manual
2-21