Power Management Setup - Abit KN8 ULTRA User Manual

3.6 Power Management Setup

Phoenix – Award WorkstationBIOS CMOS Setup Utility
ACPI Suspend Type
- USB Resume from S3
Power Button Function
Wake-Up by PME# of PCI
Wake-Up by Ring
Wake-Up by OnChip LAN
Wake-Up by Alarm
X - Date(of Month) Alarm
X - Time (hh:mm:ss) Alarm
POWER ON Function
X - KB Power ON Password
X - Hot Key Power ON
Restore on AC Power Loss
↑↓:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
ACPI Suspend Type:
This item selects the type of Suspend mode.
[S1(PowerOn-Suspend)]: Enables the Power On Suspend function.
[S3(Suspend-To-RAM)]: Enables the Suspend to RAM function.
- USB Resume from S3:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to
Enabled, any event related to onchip USB will power on the system. This item can be
configured only if the item "ACPI Suspend Type" is set to [S3(STR)].
Power Button Function:
Two options are available: Delay 4 Sec or Instant-Off. The default setting is Instant-Off. It is
activated when the user presses the power button for more than four seconds while the system
is in the working state, then the system will transition to the soft-off (Power off by software).
This is called the power button over-ride.
Wakeup by PME# of PCI:
Two options are available: Disabled or Enabled. The default setting is Enabled. When set to
Enabled, any event related to PCI cards (PME) will power on the system.
Wake-Up by Ring:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to
Enabled, any event affecting from Modem Ring will awaken a system that has powered down.
3-18
Power Management Setup
S3(Suspend-to-RAM)
Disabled
Instant-Off
Disabled
Disabled
Enabled
Disabled
0
0 : 0 : 0
BUTTON ONLY
Enter
Ctrl-F1
Power Off
F6: Fail-Safe Defaults
Item Help
F7: Optimized Defaults
KN8 Ultra-SOTES, KN8 Ultra, KN8