Table of Contents
Advertisement
Setup menu
Menu item
HD PB FMT
HD PB RATE
ACTIVE FRAME
AUTO REC
FF/REW SPEED
LOOP PB
INCOME LOCK
PREROLL(SEC)
"Default" denotes the factory settings.
Parameter
1080/23psf
For selecting the output format.
1080/24psf (Default)
<Notes>
1080/25psf
O23psf = 23.98psf, 59i = 59.94i
1080/50i
OBear in mind that if the systems for the reference frequency at the
1080/59i
1080/60i
720/59p
720/60p
OThe value which was last selected will be used as the setting when
24 (Default)
For setting the number of active frames per second when 720 has
25
been selected as the HD PB FMT setting.
30
60
ON (Default)
ON: Only those frames for which the Active Flag has been set are
OFF
OFF: All the frames which are input are recorded.
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
ON
ON: Auto recording is initiated or stopped in accordance with the
OFF (Default)
OFF: Recording is started by pressing the REC key on the front panel
<Notes>
OIf the RecStart signal is detected from the variable frame rate cam-
OThe Auto Rec setting is not saved so it should be changed as
1
This is the playback speed when FF or REW is selected.
2
<Note>
4
The value which was last selected will be used as the setting when
8 (Default)
the unit is started up.
16
32
ON (Default)
For setting whether all the clips are to be played back continuously.
OFF
ON: Playback starts from the current position, and all the clips are
OFF: Playback starts from the current position, and the selected clips
LOCK
For setting whether the playback output signals are to be synchro-
FREE (Default)
nized with the input signals.
LOCK: If input signals are supplied, the output signals are synchro-
FREE: The output signals are not synchronized.
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
0 (Default)
For inserting the prescribed signals between clips for the specified
2
period of time when clips are continuously played back.
4
<Note>
6
The value which was last selected will be used as the setting when
8
the unit is started up.
10
Description
camera side and for the unit's output frequency are at variance
when LOCK has been selected as the INCOME LOCK setting, the
playback output will be synchronized to the basic frequency at the
camera side.
Example:
If the camera's frequency is 59.94 Hz, the 720/59p format will
apply for the playback output when the 720/60p parameter setting
has been selected.
the unit is started up.
recorded on the hard disk drive. During playback, the 2:3 pull-
down mode is used for output.
Rec Flag of the input signals from the variable frame rate cam-
era or VTR.
or the REC and PLAY keys on the remote controller, and it is
stopped by pressing the STOP key.
era or VTR during FF or REW, the unit may be set to the recording
mode. Select OFF as the Auto Rec setting during FF or REW.
required.
played back continuously.
are played back to the end, after which playback stops.
nized with them. If no input signals are supplied, they are not
synchronized.
13 (E)
Advertisement
Table of Contents
