Telephone Overview; Placing Calls - NEC SL1000 User Manual

Before using Your Telephone...
Thank you for purchasing NEC SL1000 system.
Due to the flexibility built into the system, your Dialing Codes and Feature Capacities may differ
from those in this guide. Check with your NEC Authorized Supplier / System Administrator and make a
note of any differences.
NEC Single Line Telephone(AT-45) is displayed here. This User Guide describes general analogue
Single Line Telephone (SLT) procedures. Refer to the User Guide included with to your specific SLT
for details on additional key functions.
HookFlash

Placing Calls

 Place an Outside Call <Quick Access>

To change Trunk Access Code, Ask your NEC Authorized Supplier for details.

Listen for Dial Tone before dialing a Telephone Number.

For the Trunk Access Code, Ask your supplier for the details.
 Place an Intercom Call <Dial Access>

Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialing "1" changes voice/ring mode. (in case the destination is Multi-line Telephone)
Trunk Access Code
9
Extension Number
? ? ?
 INDICATOR
Flashes when you have Message
Waiting or there is an incoming call.
 REDIAL Key
Press REDIAL Key to automatically
redial the last number you dialed.
 FLASH (RECALL) Key
While on a call, press FLASH Key to
hold the line.
Telephone Number
? ? ?
- 1 -
?