Table of Contents
Advertisement
• To join a call that's already in progress, just press
• To leave the conference call, hang up normally; the other handset
remains connected to the call.
Chain Dialing
If you often have to enter a series of digits or a code number during a
call, you can save that code number to a phonebook entry and use the
phonebook to send the code number.
1. Enter the code number (up to 32 digits) into the phonebook just like
a regular phonebook entry. Be sure to enter the code number into the
phonebook exactly as you would enter it during a call.
2. When you hear the prompt that tells you to enter the number, open the
phonebook and find the entry that contains your code number.
3. Press
MENu/sElECT
the phonebook.
Voice Message Notification
If you subscribe to a voice mail service, your phone displays the voice mail
icon (
) when you have a new message.
After you listen to your messages, the message icon turns off. If it doesn't,
you can reset it: With the phone in standby, open the menu and select
Global Setup; select VMWI Reset, then select Yes.
If you change voice mail providers, you can edit your voice mail number.
Open the menu and select Global Setup/Edit Voice Mail.
USING THE ANSWERING SYSTEM
Answering System Options
You can set or change the answering system options from any handset. Just
open the menu and select Answering
Security Code
Ring Time
to send the code. If you change your mind, just close
Enter a 2-digit PIN so you can access your answering
system from any touch-tone phone (see page 20).
Set the number of rings (2, 4, or 6) before the system
answers.
Toll Saver
if you have new messages or after 4 rings if you don't.
hoME/Flash
(Answering
Setup. Select one of the following:
makes the system answer after 2 rings
or
sPEakER
Setup)
English - 17
.
Advertisement
Table of Contents
