Extension Cords - Dremel 4200 Operating/Safety Instructions Manual

BEARINGS
Model 4200 has ball bearing construction.
Under normal use no additional lubrication is
required.
Cleaning
To avoid accidents always
! WARNING
dis connect the tool from
the power supply before cleaning or
performing any main tenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety gog gles when
cleaning tools with compressed air.
If an extension cord is
WARNING
!
necessary, a cord with
adequate size conductors that is capable of
carrying the current necessary for your tool
must be used. This will prevent excessive
voltage drop, loss of power or overheating.
Grounded tools must use 3-wire extension
cords that have 3-prong plugs and receptacles.
NOTE: The smaller the gauge number, the
heav i er the cord.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
at tempt to clean by inserting pointed objects
through openings.
!
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia and house hold detergents
that contain ammonia.

Extension Cords

RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Toolʼs
Ampere
Rating
3-6
6-8
8-10
10-12
12-16
14
Certain cleaning agents
CAUTION
and
Cord Size in A.W.G.
Cord Length in Feet
25 50 100 150
18 16 16
18 16 14
18 16 14
16 16 14
14 12 —
sol vents damage
Wire Sizes in mm 2
Cord Length in Meters
15 30 60 120
14 0.75 0.75 1.5 2.5
12 0.75 1.0 2.5 4.0
12 0.75 1.0 2.5 4.0
12 1.0 2.5 4.0
— — — —
—
—