Getting Ready To Free Your Music; Connecting The Power; Turning On For The First Time; Apc - Airstream s300 User Manual

Getting Ready to Free Your Music

Connecting the Power

IMPORTANT: Please follow the following instructions in sequence.
Connect the mains lead to the back of the S300, connect to wall
socket and where applicable turn on.

Turning on for the First Time

When turning on from standby for the first time (or after an
update), the S300 will go through an initial boot up procedure
where the LED will flash blue rapidly and, because it is not
connected to a network yet, it will go into Aux mode by default.
Model : airstream s300
IC : 5928A-MA191819
FCC ID : O7VMA191819
monitoraudio.com

APC

Automatic Position Correction (APC), compensates for boundary
effects and room acoustics. It uses an integrated microphone to
measure the total frequency response in any location, accounting
for anomalies introduced by the action of room furnishings,
corners and walls. A micro-processor then compares the response
with an 'anechoic' ideal, and adjusts the S300 accordingly to
recreate the ideal sound balance in any space. APC adjustment
ensures that the S300 sounds great wherever it's placed.
The APC is manually activated and it is highly recommended to
run this with the S300 in its final location prior to connecting it
to the Wi-Fi network.
1. With the S300 powered up and in standby mode (LED
illuminated red), press and hold the input toggle button
(item 8 on page 3) and simultaneously press the standby
button to turn the S300 on.
2. The S300 will then run through the initialisation stage with
the LED on and flashing blue (pattern 2. Refer to page 17 for
the flash patterns).
3. The LED will then flash white rapidly while the test tones run.
4. After the third test tone the LED returns to blue.
5. The Standby LED will flash a preset number of times
dependent on its location. Once for an open space, twice if
next to a wall, and three times if in a corner.
EQ
x 1 =
6. The S300 will then go into AirPlay Direct mode (purple LED)
if it is the first time you have run the APC set up, or in its
last mode if the APC has been run after an update or it has
been moved.
4
EQ
x 2 = x 3 =