Via Laptop/ Pc/ Mac - Airstream s300 User Manual

Via Laptop/ PC/ Mac

HINT
The Laptop, PC or Mac must be wireless enabled with
wireless turned on.
1. Turn the S300 on from standby mode. The LED on the front
will flash blue, firstly in pattern 2 then red pattern 1.
2. When it changes to red Pattern 1, it is searching for a
wireless network. Press and hold the AirstreamConnect/
AirPlay Direct Button (Item 5 on Page 3) for approximately 12
seconds until the LED on the front flashes white (Pattern 3).
3. On the Laptop/ PC, go to the Wireless network selection
tool. For Windows Operating System go to step 4, for Mac
Operating System go to step 6.
HINT
On a Windows 7 Machine, click on the Wi-Fi strength
indicator in the bottom right hand corner. If it is
hidden, click on the little up arrow.
4. In the list will be your network (probably with "Connected"
next to it), and any other wireless networks within range.
One of them will be AirstreamConnect****** (where the 6
*'s are the last 6 digits of the S300's unique Mac Address).
Model : airstream s300
IC : 5928A-MA191819
FCC ID : O7VMA191819
monitoraudio.com
HINT
If Airstream Connect isn't displayed, click the refresh
arrows (top right corner of the window).
5. Click on AirstreamConnect, and then the Connect button.
After a few seconds, you will be connected to the Airstream
Connect wireless network.
Continue to step 7.
6. On a Mac, click on the wireless network signal strength
indicator located in the bar at the top of the desktop.
Continue to Step 7 below.
HINT
With both Windows and Mac OS's, if AirstreamConnect
isn't displayed, come out of the selection window and
then try again after a few seconds.
9