Table of Contents
Advertisement
Firmware Update.
The S300 automatically searches for software updates whenever
it is turned on (providing there is a connection to the internet).
However, there are other ways of updating the firmware. These
are manually via the internet or via a USB memory stick. Details
of all methods are outlined below.
AutomaticNotificationofFirmwareUpdate
By default the S300 is set up to inform you a firmware update is
available automatically.
1. After the S300 has gone through the initial boot up procedure and
connected to the network (blue LED stops flashing), the LED will
flash white slowly (Pattern 1) indicating that an update is available.
2. Press and hold the standby button until the LED on the front
is illuminated white.
3. Release the button and the LED will then go through various
states and colour changes indicating different stages of the
update process:
White (Flashing very fast) - Updating the firmware.
Cyan
(Illuminated for 2 seconds)
OFF - Update complete.
4. Once the update has been successfully completed, the S300
will go into standby mode (power LED is illuminated red).
5. Press the standby button and the S300 will go through the initial
start up procedure described on page 4.
HINT
If the update sequence differs from above, the update
may have failed. Please retry using the USB update
or web portal update. Also check the support section
of www.airstream-ma.com
USB Firmware Update
To update the firmware by USB memory stick the update firmware
needs to be downloaded first.
NOTE: The memory stick must be formatted as FAT32 and the file
that is downloaded saved on to the root folder of the drive.
1. On your PC/ Mac open the internet browser and go to www.
airstream-ma.com and navigate to either the S300 page or
the Support page.
2. Download and save the update file to the USB stick. When it
has been copied/ saved, safely remove the USB stick
3. Remove the power lead from the S300 and insert the USB
stick into the S300.
4. Reconnect the power and turn on the S300. The LED will
flash blue while initialising and will then illuminate blue,
purple, white or green depending on the mode it was turned
off in. The LED will flash white slowly (Pattern 1) indicating
that an update is available.
5. Press and hold the standby button until the LED on the front
is illuminated white.
6. Release the button and the LED will then go through various
states and colour changes indicating different stages of the
update process:
White (Flashing very fast) - Updating the firmware.
Cyan
(Illuminated for 2 seconds)
OFF - Update complete.
7. Once the update has been successfully completed, the S300
will go into standby mode (power LED is illuminated red),
remove the USB stick.
HINT
If the update sequence differs from above, the update
may have failed. Please retry using the USB update
or web portal update. Also check the support section
of www.airstream-ma.com
8. Press the standby button and the S300 will go through the
initial start up procedure described on page 4.
14
Model : airstream s300
IC : 5928A-MA191819
FCC ID : O7VMA191819
monitoraudio.com
Hide quick links:
Advertisement
Table of Contents
