GE Monogram ZIDI240 Owner's Manual page 18

Questions? PROBLEM
Use this
APPLIANCE
HAS ODOR
problem
solver!
DRAWER NOT
CLOSING PROPERLY
MOISTURE FORMS
ON OUTSIDE OF
APPLIANCE
MOISTURE
COLLECTS INSIDE
INTERIOR LIGHT
DOES NOT WORK
HOT AIR FROM
BOTTOM OF
APPLIANCE
APPLIANCE
NEVER SHUTS OFF
BUT TEMPERATURES
ARE OK
ACTUAL
TEMPERATURE
NOT EQUAL TO
SET TEMPERATURE
TEMPERATURE
WILL NOT ADJUST
18
The Problem Solver
POSSIBLE CAUSE
• Interior needs cleaning. See Care and Cleaning.
• Keep open box of baking soda in appliance; replace every 3 months.
• Drawer gasket is sticking or folding over. Apply petroleum jelly or
paraffin wax to the face of the gasket.
• The drawer is hitting an internal component inside the appliance.
Adjust interior components to prevent interference.
• Not unusual during periods of high humidity. Wipe surface dry.
• Drawer left open or package holding drawer open.
• Too frequent or too long drawer openings.
• In humid weather, air carries moisture into appliance when drawers
are opened.
• No power at outlet.
• Light needs replacing. Call GE Consumer Service at 1.800.444.1845
for light replacement.
• Normal air flow cooling motor. In the refrigeration process, it is
normal that heat be expelled in the area under the appliance.
Some floor coverings are sensitive and will discolor at these safe
and normal temperatures.
• Adaptive defrost keeps compressor running during drawer openings.
This is normal. The appliance will cycle off after the drawer remains
closed for 2 hours.
• Normal operation in extreme temperatures.
• Unit just plugged in. Allow 24 hours for the system to stabilize.
• Drawer open for too long. Allow 24 hours for the system to stabilize.
• Warm contents added to appliance. Allow 24 hours for the system
to stabilize.
• Defrost cycle is in process. Allow 24 hours for the system to stabilize.
• Temperature may be in lockout mode. Press both + and – pads for
5 seconds to unlock the temperature.
Double-Drawer Refrigerator