ZIDI240PII – GE Monogram Double-Drawer Refrigerator Module
(Custom panel required)
ZIDS240PSS – GE Monogram Double-Drawer Refrigerator Module
(Stainless steel)
Dimensions and Specifications (in inches)
Installation Space
Locate Outlet
10-1/2"
9"
Max.
34-1/2"-35"
1-1/2"
23-3/4" Min.
Depth Including
Handles:
25-7/8" Stainless
Steel Models Only
The cutout depth must be 24"
• Both models can be installed flush with standard cabinetry
• Designed to be built-in only. Cannot be used free-standing.
• White case and drawer sides, black vented toekick with optional
stainless steel toekick supplied.
Additional Specifications:
• A 120 volt 60Hz., 15 or 20 amp power supply is required. An
individual property grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall as shown. Electrical
must be located on rear wall as shown. Note: GFI (ground fault
interrupter) is not recommended.
Specification Created 3/04
120030
24" Min.
23-3/4" Stainless Steel
Models
24-7/8" Framed Models
34-1/2"
23-3/4"
For a complete food storage center, install two Monogram refrigeration
modules side-by-side.
Note: Reversible door swing on wine chillers/reserves and beverage
centers only. See below for combination cutout dimensions.
Important Note: Products must operate from separate, properly
grounded receptacles.
Locate Outlets
10-1/2"
9"
34-1/2" - 35"
Max.
1-1/2"
Note: Additional cutout width may be required for models with
custom panels.
Listed by
Underwriters
Laboratories
R
For answers to your Monogram,
GE
appliance questions, visit our website at
®
GEAppliances.com or call GE Answer Center
service, 800.626.2000.
24"
10-1/2"
24" Min.
9"
Max.
1-1/2"
47-1/2" Min.
GE Profile
or
®
™
®