3D Printing Systems UP! Desktop User Manual page 13

3.Operation
5.
Connect the large Power adapter (20 V)
Do not connect anything to the small socket, this is for the optional filament feeder
that can be ordered separately.
Finally, connect the printer to a computer using the provided USB cable.
6. Installing the Plastic ABS spool.
Warning: Do not uncoil or let go of the end of the coiled plastic, otherwise it will
tie it's self in a knot and then eventually, during use, it might damage the printer.
If you have, try and uncoil the plastic manually and ensure there are no knots it
the roll of plastic!
Put the ABS plastic roll onto the holder (A), (the roll should feed out from the back)
and thread the ABS filament between the feeder guide. (B)
Insert the end of the ABS filament into and through the filament tube / straw ©
UP! 3D Printer User Manual
Initialize Switch. Press down to initialize, or hold down
during printing to abort and put the printer into sleep mode.
To awake the printer either user the initialize switch or the
initialize button in the software.
12