What To Do If - Electrolux EBKGL6X User Manual

16 electrolux
2. Use a narrow, blunt object (for example
a teaspoon) to remove the glass cover.
Clean the glass cover.
3. If necessary, replace the oven lamp
with applicable 300°C heat-resistant
oven lamp.
Important! Use the same oven lamp type.
4. Install the glass cover.
5. Install the left shelf rail.
CLEANING THE DOOR
To clean the appliance door, remove it.
Caution! Be careful when you remove
the door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Removing the door
1. Open the door as far as it goes.

WHAT TO DO IF...

Warning! Refer to "Safety information"
chapter.
Problem
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
2. Fully press the clamping levers (A) on
3. Close the door until the first position
4. Hold the door with one hand on each
Installing the door
To install the door follow the procedure in
reverse.
Possible cause
The appliance is deactivated
The time of day is not set
The necessary settings are not
set
The automatic switch-off is ac-
tivated
the two door hinges.
A
(angle approximately 45°).
45°
side and pull it away from the appliance
at an upwards angle.
Put the door with the outer side down
on a soft and level surface to prevent
scratches.
Activate the appliance
Set the clock. Refer to "First
setting the time of day"
Make sure, the settings are
correct
Refer to „Automatic switch-off"
A
Solution