Prepare The Remote Control; Auto Install Radio Stations; Set Clock - Philips FWM6000 User Manual

Prepare the remote control

Note
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
1
Open the battery compartment.
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.

Auto install radio stations

When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY] (auto
install - press the PLAY button) is
displayed.
2
Press on the main unit to start
installation.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
stations with sufficient signal strength.
» When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.

Set clock

1
In the standby mode, press CLOCK to
activate the clock setting mode.
» The 12 hour or 24 hour format is
displayed.
2
Press ALB/PRESET+/- repeatedly to select
12 hour or 24 hour format.
3
Press CLOCK to confirm.
» The clock digits are displayed and
begin to blink.
4
Press ALB/PRESET+/- to set the hour.
5
Press / to set the minute.
6
Press CLOCK to confirm.
Tip
•
To view the clock during play, press CLOCK.
EN
11