Glass Cooktop - GE J2S968 Owner's Manual

Cleaning the glass cooktop.
Clean your cooktop after
each spill. Use CERAMA
®
BRYTE Ceramic Cooktop
Cleaner.*
Use a CERAMA BRYTE ® Cleaning
Pad for Ceramic Cooktops.*
The CERAMA BRYTE ® Ceramic
Cooktop Scraper* and all
recommended supplies are
available through our Parts Center.
See instructions under "To Order
Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
34
Control Lockout
Begin by locking the cooktop; see the
Control Lockout section.
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE
Cooktop Cleaner* on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with CERAMA
BRYTE ® Ceramic Cooktop Cleaner.*
This helps protect the top and
makes cleanup easier.
Daily use of CERAMA BRYTE
Ceramic Cooktop Cleaner* will
help keep the cooktop looking new.
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than the
pad included with your cooktop.
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Spread a few drops of CERAMA
BRYTE ® Ceramic Cooktop Cleaner*
on the entire burned residue area.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Use a single-edge razor blade
scraper at approximately a 45°
angle against the glass surface
and scrape the soil. It will be
necessary to apply pressure to the
razor scraper in order to remove
the residue.
After scraping with the razor
scraper, spread a few drops of
* For Canadian models, use a Camco-approved equivalent when CERAMA BRYTE
Contact Camco Replacement Parts to order replacement cleaning products.
® Ceramic Remove the burner grates and vent
grille.
Shake the cleaning cream well.
Apply a few drops of CERAMA
BRYTE
directly to the cooktop.
Use a paper towel or CERAMA BRYTE
Cleaning Pad for Ceramic Cooktops* to
clean the entire cooktop surface.
Use a dry cloth or paper towel
® to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO NOT heat
the cooktop until it has been cleaned thoroughly.
Using a CERAMA BRYTE
Cleaning Pad for Ceramic
Cooktops*, rub the residue area,
applying pressure as needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE
and a paper towel.
CERAMA BRYTE
Cooktop Cleaner* on the entire
burned residue area. Use a
CERAMA BRYTE
for Ceramic Cooktops* to remove
any remaining residue.
For additional protection,
after all residue has been
removed, polish the entire
surface with CERAMA BRYTE
Ceramic Cooktop Cleaner* and a
paper towel.
® Ceramic Cooktop Cleaner*
®
® Ceramic Cooktop Cleaner*
® Ceramic
® Cleaning Pad
®
® products are not available.
®