Control Lockout - GE J2S968 Owner's Manual

Using the clock, timer and control lockout.
Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
*
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Touch the KITCHEN TIMER
ON/OFF pad (TIMER pad on
Canadian models).
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the KITCHEN TIMER
ON/OFF pad (TIMER pad on
Canadian models) and begin again.
Touch the START pad.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by
touching the KITCHEN TIMER ON/OFF pad
(TIMER pad on Canadian models), then
touch the number pads until the time
you want appears in the display.
To Cancel the Timer
Touch the KITCHEN TIMER ON/OFF pad
(TIMER pad on Canadian models) twice.

Control Lockout

Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
To lock/unlock the controls:
Touch the 9 and 0 pads at the same
time for 3 seconds, until the display
shows LOC ON.
To unlock the control, touch the 9
and 0 pads at the same time for
3 seconds, until the display shows
LOC OFF.
* For Canadian models, see the French section for equivalent pad nomenclature.
www.GEAppliances.ca (Canada)
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad
(TIMER pad on Canadian models) is
touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the KITCHEN TIMER ON/OFF pad
(TIMER pad on Canadian models) and
then touching the number pads to enter
the new time you want.
When this feature is on and the touch
pads are touched, the control will beep
and the display will show LOC ON.
s
The control lockout mode affects all touch
pads. No touch pads will work when this
feature is activated.
s
The adjustment will be retained in memory
after a power failure.
ge.com (U.S.)
13